Energy storage container charging and discharging 2 2KWH process

Can simultaneous charging and discharging process be used in heat exchangers?

However, the work on the cases of simultaneous charging and discharging (SCD) process receives attention in just recent 15 years and is still inadequate. To the authors’ best knowledge, Liu et al. studied an SCD process in a heat pipe heat exchanger with PCM in 2006.

What is the balanced charging/discharging power?

The balanced charging/discharging power is approximately 52 W. By comparison of Fig. 6 and Fig. 8 (b), it can be seen that the balanced power is still lower than that under the equal flow rate. It is noted that the initial charging power decreases to approximately 130 W, owing to the reduction of the charging flow rate.

Can a latent thermal energy storage system be a prototype?

The design of system and the selection of energy storage material can be a prototype for the future studies on the simultaneous charging and discharging process of latent thermal energy storage systems with efficient heat transfer. Y. Fang: Conceptualization, Methodology, Investigation, Writing - original draft.

When phase change material in energy storage unit is initially solid?

When the phase change material in energy storage unit is initially solid, the heat transfer mode in the system is initially an energy storage process, and the energy storage unit experiences a process of temperature decrease with a duration of approximately 7500 s before the stable state.